AC meter MID, 32A - Direct kilowatt-hour meter 5A WSZ15D-32A MID

AC meter MID, 32A - Direct kilowatt-hour meter 5A WSZ15D-32A MID – Eltako – 28032015 – 4010312501627: AC meter MID, 32A WSZ15D-32A MID meter type electronic, rated current (In) 5A, maximum current (Imax) 32A, rated voltage (Un) NL 230 ... 230V, frequency 50 ... 50Hz, accuracy class B, polarity 1-phase, version Direct measurement, active power energy type, suitable for purchase, one-tariff tariff version, backstop, calibrated, Measuring Instruments Directive approval, optical pulse output, pulse type S0, pulse rate 2000 ... 2000imp/kWh (kvarh), display type digital, mounting type REG, width in division units 1, Design of the interface others, number of digits 7, degree of protection (IP) IP20, only calibrated meters are permitted for electricity billing according to Section 25 of the German calibration law. Non-compliance is an administrative offense according to paragraph 19. Maximum current 32A, standby loss only 0.4 watts. Modular installation device for mounting on mounting rail DIN-EN 60715 TH35. 1 pitch unit = 18mm wide, 58mm deep. Accuracy class B (1%). With S0 interface. This AC meter measures the active energy based on the current flowing between the input and the output. The self-consumption of only a maximum of 0.4 watts active power is not measured and not displayed. 1 phase conductor with a current of up to 32A can be connected. The starting current is 2OmA. With an expected load of more than 50%, a ventilation distance of 1/2 module to devices installed next to it must be maintained. If necessary, use the spacer DS12. Two N terminals for safe cross-wiring of multiple meters. The 7-segment LC display can be read twice within two weeks even without a power supply. To do this, press the button. Below the display there is a button with which you can scroll through the menu according to the operating instructions. First, the backlight turns on. Then the total active energy, the active energy of the resettable memory and the instantaneous values of active power, voltage and current can be displayed. The power consumption is shown on the display with a bar that flashes 1000 times per kWh. Error message: In the event of a connection error, the backlight of the display flashes.